VERTIDRIVE B.V. | GIETERIJWEG 15 | 3089 JZ ROTTERDAM | THE NETHERLANDS - 22 -
T +31 (10) 763 02 00 | E SALES@VERTIDRIVE.COM | W WWW.VERTIDRIVE.COM
CHAMBER OF COMMERCE 24448205 | VAT NL 8201.77.064.B01
In all cases where we act as provider or supplier, our offers, orders placed with us, and agreements concluded with us are subject to the conditions and requirements laid down by the Netherlands Metal Association (the ‘Metaalunievoorwaarden’).
These conditions and requirements are filed with the registrar of the District Court of Rotterdam.
Fall arrester and (optional) winch system
Single fall arrester (left) or dual fall arrester (right) setup for the V700 Series robot.
For worker safety it is mandatory to use a fall arrester attached to the robot as shown above.
It is very important to install the fall arrester before placing the robot on the surface. This will ensure that the robot is
always secured, and users are safe in case the robot detaches from the surface for any reason.
Always use slings and straps that are in accordance with local regulations. Replace slings and straps if any damage
is found. Inspect these materials before usage according to the inspection schedule or start-up checklist.
Setup with (optional) transport frame with integrated winch system
To Next Page
Loading...
