VERTIDRIVE B.V. | GIETERIJWEG 15 | 3089 JZ ROTTERDAM | THE NETHERLANDS - 38 -
T +31 (10) 763 02 00 | E SALES@VERTIDRIVE.COM | W WWW.VERTIDRIVE.COM
CHAMBER OF COMMERCE 24448205 | VAT NL 8201.77.064.B01
In all cases where we act as provider or supplier, our offers, orders placed with us, and agreements concluded with us are subject to the conditions and requirements laid down by the Netherlands Metal Association (the ‘Metaalunievoorwaarden’).
These conditions and requirements are filed with the registrar of the District Court of Rotterdam.
Part replacement instructions
VertiDrive can supply any part of the system as a spare part. See 322027 V700 Series Robot – IPM supplied with the
robot for details and part identification. When ordering parts always specify the part number and provide a brief
description of the problem and why a part needs to be replaced. VertiDrive will provide instructions for part
replacement with the supply of the new parts.
Cleaning
To ensure proper robot functionality and performance, it is important to keep the robot clean. It is recommended to
clean the robot quickly at the end of each working day and thoroughly between jobs. This is especially important for
all moving parts (swing arm, drives, magnet height adjustment and lift mechanism). Any dirt or other contamination
can be removed by using pressurized air, or low-pressure water (max 2 bar).
If there is excessive build-up of dirt on or near the magnets, it can influence the height adjustment mechanism of the
magnets. If the dirt contains metal particles (e.g., residue from the surface cleaning) it can be very hard to remove
this contamination from the magnet surface. Use a brush or a damp cloth in this case. In extreme cases it might be
required to disassemble the magnet and remove it for cleaning. Disassembly and removal of the magnet for cleaning
may only be done by VertiDrive or trained and qualified representatives.
Clean the control box regularly, preferably using pressurized air. In the case of a control box with cooling (optional),
inspect the cover and fan on the outside of the cabinet for dust and / or dirt build-up before each job, clean with
pressurized air if needed. If the fan stops moving or is making abnormal sounds, shut off the system and clean the
cover and fan. If needed, the cover can be removed for better cleaning.
To Next Page
