iVERTIV™ - Liebert
®
EFC - UM - 10040805MAN_ENG - 30.03.2023
This document, written in English, is the original version.
indicates a hazardous situation which, if not avoided, will result in death or serious injury.
indicates a hazardous situation that, if not avoided, result in death or serious injury.
indicates a hazardous situation that, if not avoided, result in minor or moderate injury.
indicates a property damage message.
This unit operates and restarts automatically.
If the electrical connection is live, there are residual risks: electric shock, burns, moving parts, automatic restarting
from the remote control.
•
The ON/OFF switch the control panel does not isolate the power from the unit, even in the “” mode. To
cut the power supply, open the insulation device (main switch) which is positioned on the electrical panel cover,
behind the door:
This manual was prepared to enable the end user to carry out only the operation that can be done with the panels
closed.
The panel key supplied with the unit must be kept by a person responsible for the maintenance.
Before proceeding with installation, read all instructions, verify that all parts are included and check the nameplate to
make sure the voltage matches available utility power.
The manual is retained for the entire service life of the machine;
The user reads the manual carefully before carrying out any operations on the machine;
The unit control must be used exclusively for the purpose which it is intended for; the manufacturer takes no liabil ity
Unscrew the door and open it to access the main switch.
• After opening the door pay attention to the cable and components still energized.
•
Here shown the single unit left, on
the single unit right the electrical panel and
main switch are on the opposite side.
To Next Page
Loading...
