Vertiv NetSure 7100 Series User Manual

Vertiv™ NetSure™ 7100 Series -48 VDC Power System User Manual
15
4 Maintenance
4.1 System Maintenance Procedures
It is recommended to perform the maintenance procedures listed in Table 4.1 every 6-months to ensure continual system operation.
Table 4.1 Maintenance Procedures to be Performed at 6-Month Intervals
PROCEDURE REFERENCED IN
Check ventilation openings for obstructions such as dust, papers,
manuals, etc.
--
Inspect and tighten all installer's connections. IM582127000, “Making Electrical Connections” section.
4.2 Adding a Rectifier Module to an Existing Spec. No. 588705000,
588705400, or 588705500 Module Mounting Assembly
To increase system current capacity, a rectifier module can easily be added to an existing Spec. No. 588705000, 588705400, or
588705500 module mounting assembly that contains an empty rectifier module mounting position.
It is recommended that the current limit point be checked whenever a rectifier module is added to or removed from a 588705000,
588705400, or 588705500 module mounting assembly in the power system. Refer to “Checking the Controller’s Current Limit Point
after Adding or Removing a Rectifier Module or Converter Module” on page 44.
The rectifier module being added is assigned by the controller the lowest available identification number. If desired, you can change
the identification number. Refer to the NCU Instructions (UM1M830BNA) for a procedure.
• For rectifier module installation instructions in a 588705000 and 588705500 shelf, refer to Rectifier Instructions
(UM1R483500e).
• For rectifier module installation instructions in a 588705400 shelf, refer to Rectifier Instructions (UM1R483500e3).

Vertiv NetSure 7100 Series Specifications

General

Brand	Vertiv
Model	NetSure 7100 Series
Category	Power Supply
Language	English