Vetek DGT - Page 14

DGT / DGT60 / DGTQ / DGTP
14
NOTES:
For the functioning details, refer to section 8 "SELECTABLE FUNCTIONING MODES", USER MAN.REF.
Once the functioning mode is selected, if there’s a printer, the standard printout relative to the printer selected in
the SEtuP >> SErIAL >> Com.Prn >> PrMODE parameter will automatically be enabled. One can load the
default parameters by executing the default of the selected printout (see section 8 )
• Scr.SAv: SCREEN SAVER (§)
If the indicator has the date/time option, it is possible to enable the "Screen Saver" function: after a programmable
time (from 1 to 255 minutes) that the scale is unloaded, the time is shown on the display, in the "HH-MM.SS"
format. As soon as a weight variation is detected, or a key is pressed, the indicator displays the current weight
once again.
 no Disabled.
 yES Enabled: one is asked to enter the time which the indicator waits to display the time, after the weight has
become stable and keys are not pressed.
(!) no
(§) The parameter is not displayed if there is no date/time option or if one has selected the rEPE functioning
mode, FmodE >> FunCt parameter.
NOTE:The date/time function is standard fitted in the DGTP version.
• irConF REMOTE CONTROL CONFIGURATION (§)
With the 4-key remote control (optional) it is possible to remote the ZERO, TARE, MODE and ENTER/PRINT
keys, or just the TARE key.
ir no Remote control disabled.
ir 1 All the remote control keys work as the TARE key.
ir 4 The remote control keys work as ZERO, TARE, MODE and ENTER/PRINT.
(!) ir no
(§) The parameter is displayed with the DGT60 model.
• rEACt REENABLING OF THE PRINTOUTS AND THE INDICATOR FUNCTIONS(§)
While using the indicator, it is possible to incur in the "no.0.unS" error shown on the display accompanied by an
acoustic signal; this means that the printout or the function which one wants to carry out must be reenabled (in
order to avoid accidental executions).
It is possible to set the reenabling in the following modes: "passage of the net weight by zero", "weigh instability"
or "always".
 ZEro passage of the net weight by zero
 inSt instability
 ALWAyS always (§) This parameter is not visible if by selecting the horizontal totaliser or vertical totaliser
functioning mode one sets the automatic totalisation mode.
(!) ZEro
(§) The parameter is not displayed if one has selected the rEPE or MAStr functioning mode, FmodE >> FunCt
parameter.
• L.int DISPLAY BACKLIGHT INTENSITY (§)
Through this step one selects the intensity of the backlighting or of the LED display:
Lint 1 (minimum), Lint 2, Lint 3, Lint 4 (maximum).
(!) Lint 1
(§) The parameter is displayed with the DGT60 model.