DGT / DGT60 / DGTQ / DGTP
40
display.
Instrument response: [CC]OK<CR LF>
With approved instrument:
The minimum settable time is 1 millisecond (0001HEX), and maximum settable time is 5 seconds (5000 milliseconds,
1388 HEX).
PC confirmation command
[CC]PCOK<CR LF>
The indicator shows on the display the "-PCOK-" message for about 2 seconds.
Instrument response: [CC]OK<CR LF>.
Serial command for setting the apw (only for the counting operating mode)
[CC]SPMUvvvvvvvv <CR LF> or [CC]Xvvvvvvvv<CR LF> (short command).
in which: vvvvvvvv is the apw (up to 8 characters with decimal point); maximum value: 9999.999
System response: [CC]OK<CR LF>.
For example, to set a APW of 1.55 g, the command is the SPMU1.55<CR LF> or SPMU0001.550 <CR LF> and all
the various combinations adding zeros to the right or to the left but taking into consideration that the maximum length
of the APW field is 8 characters.
NOTES:
- The APW are not accepted in the SPMU.12<CRLF> format; these must be in the SPMU0.12<CRLF> format.
- the APW are not accepted equal to zero.
Serial command which supplies the indicator status
[CC]STAT<CR LF>
Instrument response:
[CC]STATXX<CR LF>
in which XX is a decimal value which supplies the status of the indicator; the possible values are:
XX indicator status
00 normal scale status
01 normal scale status in input
02 instrument in technical set-up
03 instrument in boot phase
04 instrument in rx/tx set-up phase
05 instrument in test phase of the serial ports
06 instrument in print test
07 instrument in firmware update phase
08 instrument in stand-by
09 instrument in automatic zero phase
10 instrument in change channel
11 instrument in inputs test phase
Key pressure simulation command
[CC]KEYPXX<CR LF>
in which XX is the code of the pressed key:
00: scale ZERO key; 01: TARE key; 02: MODE key; 03: PRINT key; 04: C - ON/OFF and INFO key.
Instrument response: OK<CR LF>: accepted command.
In case the simulated key has two linked functions (key briefly pressed or at length, like the TARE key), if the KEYP
command is followed by the release command of the (KEYR) key within a maximum time of 1,5 seconds, the simple
function will be executed (key briefly pressed); otherwise the second function will be made (key pressed at length).
Key pressure simulation command
[CC]KEYR<CR LF>
Response: [CC]OK<CR LF>
NOTE: The instrument does not transmit the OK answer to the following short commands: P, Q, T, W, X, Z.
To Next Page
Loading...