DGT / DGT60 / DGTQ / DGTP
56
*****************************************************************************************************************************
DEFAuL PRINTOUT DEFAULT
Through this StEP one enables the default printing relative to the selected functioning mode.
The default sets, in each of the following steps, the value marked with the (!) symbol.
FiLdS PRINTING FIELDS
Through this StEP it is possible to select which fields to be printed among those available:
G; n; t; G n; G t; n G; n t; t G, t n; G n t; G t n; n G t; n t G; t G n, t n G (in which G is the gross
weight; n is the net weight and t is the tare weight).
(!) G t n
hEiGht FONT HEIGHT SELECTION FOR PRINTING THE WEIGHT DATA, DATE AND TIME,
PROGRESSIVE NUMBERS AND ID’S:
ChAr 1 normal height
ChAr 2 double height
(!) ChAr 1
bArC PRINTS THE BAR CODE
In this step one programmes the printing of the 39 CODE (if "TPR" has been selected in the
"PrModE" step), which will be printed before the printing of the date and time:
no does not print the bar code.
yes.tot prints the bar code; in the totalizer functioning mode it is printed just in the single
totalisations.
SuM prints the bar code; in the totalizer functioning mode it is printed just in the partial total.
both prints the bar code; in the totalizer functioning mode it is printed in the totalizations as
well as in the partial total.
(!) no
NOTES:
- the weight values are expressed in 6 digits without decimal point and with the possible non
significant zeros present.
- between a weight value and the following one a space is inserted.
- the bar code is printed as the last data, after the weight values, possible numeric codes and ticket
number, but before the date and time (with DP190 or TPR printer).
To Next Page
Loading...