DGT / DGT60 / DGTQ / DGTP
57
THE FOLLOWING PARAMETERS ARE VISIBLE ONLY IF IN THE PREVIOUS STEP A PARAMETER DIFFERENT
FROM "no" HAS BEEN SET.
VdbAr SELECTING THE BAR CODE’S VERTICAL DISTANCE OF THE PRECEDING TEXTS:
In lines with normal height font, programmable value: 0…9. (!) 0
LMbAr SELECTION OF LEFT MARGIN
Expressed in 1/8 of a mm (from 1 to 99). (!) 01
WbAr SELECTION OF BAR CODE FONT WIDTH:
Programmable value: W1…W3
(!) W1
hbAr SELECTION OF BAR CODE FONT HEIGHT:
Expressed in 1/8 of mm (from 0 to 255) (!) 000
bArFS SELECTION OF PRINT FIELDS IN THE BAR CODE:
Programmable value:G; n; t.
In which G is gross weight, n is net weight and t is tare weighing.
(!) G
PntVb PRINTING OF THE BAR CODE’S NUMERIC FIELD
This step allows to select the printing of the bar code’s numeric field:
no the numeric field is not printed.
undEr under the bar code
AboVE above the bar code
Ab/un both above as well as below the bar code.
PtESt PRINT TEST
By pressing PRINT, a label is printed of the fields previously selected, but with fixed weight values.
The print test depends on the selected functioning mode:
Std mode: the first time the fields with the unit of measure in kg are printed, the second time the fields with the
unit of measure in lb are printed, and on this way
ntGS, StP G, StP n, VISS, Alibi, inout mode: simple printout.
MAStEr mode: not settable.
HoLD mode: the first time the fields without the "HOLD" indication are printed, the second time the fields with
the "HOLD" indication, and on this way.
PEAk mode: the first time the fields without the "PEAK" indication are printed, the second time the fields with
the "PEAK" indication, and on this way.
GROSS 1.000kg
TARE 0.000kg
NET 1.000kg
001000
To Next Page
Loading...