When tension test on, waiting time for
the motor to reset after opening the
wind cover
In the on condition, the tension test is
performed automatically after the
fusion is completed
When on, automatic fusion when the
wind cover is closed
When on, no fiber is detected and the
heating button is pressed, it will also
heat up
When on, automatic heating when
the heater cover is closed
When on, the fusion splicer
automatically adjusts the current
level according to the real time fusion
situation
When on, the user can press the start
button to force the fusion to continue
if the fusion process detects a failed
angle or a mismatch of fibers
Turn on/off 5V/2A power supply
When on, the system automatically
saves the fused image after the
fusion is completed
To Next Page
Loading...
