operating instructions, as incorrect use of the battery may
result in heat, rupture, explosion, fire or personal injury
Caution
Do not use and store the fusion splicer in an environment
with high temperatures and humidity as this may cause
damage to the equipment.
Do not touch the heat shrink tube during or just after
heating, as the heat shrink tube is very hot and may cause
burns.
Do not touch the fusion splicer, AC power cord and AC plug
when your hands are wet as this may cause electric shock.
Do not use any chemicals other than alcohol to clean
microscope lenses, V-grooves, displays etc. as this may
result in blurred images, smudges etc. and may even cause
corrosion and damage to the equipment.
When used in dusty environments, appropriate dust control
measures must be taken to avoid large amounts of dust
entering the inside of the machine and causing it to
malfunction.
Do not subject the fusion splicer to strong vibrations and
shocks, as this may cause damage to the machine. Use a
special carrying case for transporting or storing the fusion
splicer.
Use the power adapter supplied as standard, if you use
your own adapter, the fusion splicer may not work properly.
Please check the battery level before using the fusion
splicer. If the battery level is low or there is an under voltage
alarm, please recharge the battery pack in time. (When the
battery is fully charged but still has a very short operating
time, please replace the battery with the specified type in
time).
To Next Page
Loading...
