Open the windproof cover, wipe the surface of the
presser foot with a fine cotton swab dipped in alcohol,
make sure it is clean, and then dry the presser foot with
a dry cotton swab.
(1) Turn off the power of the fusion splicer and open the
windproof cover.
(2) Gently and carefully wipe the lens with a fine cotton
swab
(3) Turn on the power and do a light source calibration
in the equipment
maintenance
Note: Do not touch the electrodes when cleaning, and
do not touch the lens
with hard objects.
Dust and dirt are easy to deposit on the heater, please
clean the heating plate regularly with a dry cotton swab.
Cleaning the fiber optic
presser foot
To Next Page
Loading...
