7/7
11. Instructions for Laser
Please wear the protective glasses before operating the laser!
When all the connections are completed, turn on the power, and the laser is standby for working. The indicator light on the top of
the laser is continuous lighting at this time.
Turn on the weak light and adjust the focal length
Please lay the materials to be carved flat under the laser.
Please turn on the weak light in the engraving software or press the weak light switch on the top of the laser module. Then the
red light will flash and the weak light on. Laser spots can be seen on the materials at this time. Adjust the height of the module, when
the laser spots are smallest and clearest, it is the optimum state for laser engraving. Or use the focal length measuring piece to adjust
the module height so that the distance from the lower edge of the module protective cover to the engraved object is equal to the
height of the measuring piece.
It is important to understand that this weak light switch on the top of the laser module is not controlled by engraving control
software. So be sure to switch back to normal (make sure that weak light is off) before you start engraving.
12. Notice
(1) The shape of all parts above in this description is only as a sign. There may be a difference between the actual parts and the
parts in the installation instructions. Please refer to the shape of the actual parts purchased.
(2) Please pay attention to the sequence of the installation steps to avoid repeated disassembly.
(3) Make sure hibernate and sleep are disabled when working long hours. This feature may cause the laser to continue to glow
out of control, and burning on the table.
13. Update
Our software will be updated continuously.
Please visit our website: www.vevorengraver.com for more new products and software.
Please be sure to download the VevorWorks for this machine.
Please refer to the Software Installation Manual for control software instructions.
Please contact us if you have any questions.
Powered by VEVOR 2022
To Previous Page
Loading...
