11. ALWAYS ensure the switch is off before plugging in to mains. Avoid accidental
starting.
12. ALWAYS concentrate on the job in hand, no matter how trivial it may seem. Be
aware that accidents are caused by carelessness due to familiarity.
13. ALWAYS keep your proper footing and balance at all times - don’t overreach.
For best footing, wear rubber soled footwear. keep floor clear of oil, scrap wood,
etc.
14. ALWAYS wear proper apparel. Loose clothing or jewellery may get caught in
moving parts. Wear protective hair covering to contain long hair.
15. ALWAYS guard against electric shock. Avoid contact with earthed
surfaces..pipes, radiators etc.
16. NEVER operate machine while under the influence of drugs, alcohol or any
medication.
17. NEVER leave machine running unattended. Turn power off. Do not leave the
machine until it comes to a complete stop.
18. NEVER force the machine, it will do a better and safer job at the rate for which
it was designed.
19. NEVER use power tools in damp or wet locations or expose them to rain.
Keep your work area well illuminated. Do not use in an explosive atmosphere
(around paint, flammable liquids etc.). Avoid dangerous environments.
ADDITIONAL PRECAUTIONS FOR BELT AND DISK SANDERS
1. ALWAYS wear ear protectors/defenders when using this machine.
2. ALWAYS wear a dust mask when using this machine. Be aware of harmful or
toxic dusts produced when sanding some woods, lead paint etc.
3. ALWAYS use the sandbelt support or table to support the workpiece.
4. ALWAYS check to ensure the table, sand belt support and attachments are
secure before starting.
5. ALWAYS maintain a clearance of 1.5 - 2 mm between table and sanding belt or
disc.
To Next Page
Loading...
