6. ALWAYS hold the workpiece firmly so that it cannot be ripped from your hands
7. ALWAYS feed the workpiece against the direction of rotation of the disc. i.e the
LEFT side of the disk
8. ALWAYS keep the mains cable well away from the machine and ensure an
adequate electrical supply is close at hand so that the operation is not
restricted by the length of the cable.
9. ALWAYS use a dust extraction device, properly connected to the dust
extraction port
10. ALWAYS ensure that nails or any foreign objects have been removed from a
workpiece beforehand. Nails etc., will destroy the belt or disk.
11. NEVER allow the ventilation slots in the motor to become blocked.
12. NEVER sand pieces which cannot be held firmly by hand.
WARNING! Use ONLY for sanding WOOD. DO NOT DO NOT USE for sanding
asbestos, or materials containing asbestos, painted surfaces, or materials
which produce toxic.
WARNING: THIS APPLIANCE MUST BE EARTHED
IMPORTANT: The wires in the mains lead are coloured in accordance with the
following code:
If this appliance is fitted with a plug which is moulded on to the electric
cable (i.e. non rewireable) please note:
1. This plug must be thrown away if it is cut from the electric cable. There
is a danger of electric shock if it is subsequently inserted in a socket outlet.
2. Never use the plug without the fuse cover fitted.
3. Should you wish to replace a detachable fuse carrier, ensure that the
correct replacement is used (as indicated by marking or colour code).
4. Replacement fuse covers can be obtained from your local dealer, or an
electrical stockist.
To Next Page
Loading...
