2. Press and hold the feeder button for about 3 seconds until you hear
one beep, printer will run the Intelligent Label calibartion process. This
process is recommended each time you change the label sizes.
1. Press once: Feed a blank page / Pause / Resume
(1) When the printer is in ready status and there are no holding jobs,
press the feeder button once, the printer will feed a blank page.
(2) When the printer is running, press once will pause the job, press
once again will resume the job.(Although it is not recommended, if
you want to urgently stop an unwanted printing task, you may turn
off the power directly and don' t forget to cancel the print task from
the computer at the same time).
3. Press and hold the feeder button for about 5 seconds until you hear
two beeps.Printer will print a test page. If the test page looks good, it
indicates that the printer head is working properly.
4. Press and hold the feeder button for about 15 seconds until you
hear five beeps. This will reset the printer to the factory setting. This
process is harmless to the printer and can be used if you want the
printer to recover from an unknown error.
FEEDER BUTTON INSTRUCTIONS
22
To Next Page
Loading...