User
26
7 IMPORTANT NOTICES
Boiler installation and setting can be performed only by a servicing organization trained by the manufacturer.
The boiler can be used only for the purpose for which it has been designed.
Only adult persons are allowed to operate the boiler in compliance with this manual.
The boiler is not designed for the use by persons (incl. children) whose physical, sensual or mental disability or lack of
experience and knowledge prevent them from a safe use of the appliance unless they are supervised or if they were not
instructed on the use of appliance by a person responsible for their safety.
Children should be supervised in order to ensure that they do not play with the appliance.
The boiler is fully automatic therefore we do not recommend disconnecting it from electric power.
The boiler is equipped with automatic anti-freezing protection (if electric power is supplied).
It is forbidden to intervene with any secured parts.
No flammable objects can be placed, built or suspended near the boiler and flue gas ducting (a safe distance of the appliance
from flammable materials in the main radiation direction is 50 mm and 10 mm in other directions).
If any building reconstructions are performed in the close vicinity of the boiler, turn off the boiler with a sufficient lead time and
protect it from polluting.
Avoid cleaning of the boiler by flammable or explosive agents.
In winter (if leaving for a holiday, for instance) it is necessary to ensure the necessary inspection of functionality of the boiler and
the entire heating system in order to avoid possible water freezing resulting in equipment damage due to some external reasons
(such as electricity or heating gas supply outage, and so on).
The manufacturer recommends the use of antifreeze Alphi 11 manufactured by Fernox or X500 manufactured by Sentinel
approved for the Sermeta heat exchangers.
In case of boilers with flue gas exhaust into the surrounding environment through the peripheral external wall of the building it is
necessary to check whether the condensed water from flue gas in the exhaust basket does not freeze in a frosty weather.
The boiler is fed with 230 V/50 Hz electric power supply.
While checking the tightness of the gas distribution and the valve connection, it is necessary to be careful not to wet the coil of
the gas valve!
In case of fire, extinguish the boilers as electric equipment.
Pay attention to any gas leakage (in case of any suspicion of gas leakage, shut off the gas intake and ventilate the area - call a
service firm). The gas valve under the boiler must always be kept freely accessible.
It is necessary to avoid combustion air pollution with halogen hydrocarbons (contained, for example, in sprays, solvents, paints,
glues) and with dust.
During assembly, installation and operation of the appliance it is necessary to comply with the standards that apply in the
relevant country of destination.
If you fail to meet these conditions you cannot require guarantee repairs.
8 Instructions for Product Disposal After Its Service Life
VIADRUS a.s. is a contractual partner of EKO–KOM a.s., its client number being EK – F00060715
Packaging is in compliance with EN 13427.
We recommend disposing the packaging in the following way:
- plastic foils, carton cover, use the Scrap Materials
- the wood base is intended for single using and it cannot be further reused. Its disposal is subjected to Act No. 477/2001 Coll. and
185/2001 Coll. as amended.
We recommend disposing the individual boiler parts as follows:
- exchanger, use the Scrap Materials
- pipe distributions, use the Scrap Materials
- other metal parts, use the Scrap Materials
- boiler frame insulation material, through a contractor dealing with waste collection and disposal
Upon losing the utility value of the product, it is possible to return the product back (if applicable), in case the originator states it is
waste, the waste should be disposed according to the provisions of the effective legislation in the particular country.
To Next Page
Loading...
