OMG100N1.17 G100 Range
Page 26 LANDTEC North America, Inc., DBA
VIASENSOR
Note: For further information please refer to section ‘8.0 Problem Solving’ of this
manual.
5.11 Battery/Charging
Note: Fully charge the unit before use when the instrument is first received or if the
instrument has been in storage for six months or more.
The battery used in the instrument is 2 Ah Lithium-Ion cell. The instrument must be
charged using the power supply supplied with your instrument. The power supply supplied
is intended for indoor use only. Please ensure adequate ventilation while charging.
Note: Although the instrument can be powered via the USB connector it cannot be
charged via USB.
When plugged into the power supply the instrument will power on and display charging.
When complete the display will change to show that the instrument is charged. To switch
the instrument ON whilst charging or charged is displayed, the operator will need to switch
the instrument off and then on again.
Instrument:
Power Supply:
Note: A full charge will take approximately 3 hours. Typically, a fully charged battery
will last 8-10 hours.
When the instrument is already powered on, the operation is slightly different as the
battery icon changes to a flashing plug symbol. This will stop flashing when the charge is
complete.
Input 100 – 240V ~ 60/50 Hz 120mA
Output 5V 1000mA 5VA
Input 100 – 240V ~ 60/50 Hz 120mA
Output 5V 1000mA 5VAOutput 5V 1000mA 5VA
To Next Page
Loading...