Viasensor G100 Series - Event Log Details

G100 Range OMG100N1.17
 Copyright 2009 LANDTEC North America, Inc., DBA VIASENSOR Page 51
12.0 Event Log
The following events are recorded in the instrument’s event log. The event log can only be
downloaded using the additional Analyzer Data Manager software. Please refer to the
Analyzer Data Manager Software manual for further details.
Event
Data
Cold Start/Reset
Type of start (MCUSR, boot_key)
Firmware Version
Description
Set time
Before and After
Set date
Before and After
Re-flash requested
None
Restore to factory settings
Type
Comms clear memory
Type 0=Readings, 1=Event Log
Change contrast
Before and After
Change flow fail current limit
Before and After
Battery less than critical voltage
Critical, Actual
RTC date/time invalid
None
Factory calibration invalid or overdue
Date, difference
Service invalid or overdue
Date, difference
Power on self-test, sensor out of range
Channel, reading, limit
User calibration set zero OK
Before, After
User calibration set span OK
Target, Before, After
User calibration set zero failed
Target, Reading
User calibration set span failed
Target, Reading
Attempt to store when readings memory full
Max
Readings memory nearly full
Limit, Actual
Change logging mode
Status, Interval, Pump time
Change logging mode ID
ID
Flow fail current limit exceeded
Limit, Actual