VICI M50 - Appendix B: Setup for Multipump Operation; Connections

24
7 pin connector Signal
 
 
 
 
 
7 pin connector Signal
 
 
 
 
 
7 pin connector Signal
 
 
 
 
 



Set system variables to the following values:
Set the device address using the address DIP switches:












MicroLYNX #1 MicroLYNX #2 MicroLYNX #n
Four wire RS-485
7 pin connector Signal




 
7 pin connector Signal




 
7 pin connector Signal




 



Set system variables to the following values:
Set the device address using the address DIP switches:












MicroLYNX #1 MicroLYNX #2 MicroLYNX #n
Two wire RS-485 e.g.,
Appendix B: Setup for Multipump Operation
Connections
Make up cables using the following guidelines. Note that communication
withthePCisassumedtobeviaRS-232.
If you are using an RS-232 to RS-485 converter, treat the converter as the
Host,withallMicroLYNXesconguredasslaves.