iCNC XT
3-8 INSTALLATION Manual 0-5299
3.6 Down Draft and Laser Pointer Wiring (XT 211 & 231 ONLY) OPTIONAL
You can control the fume extraction manually or by automatic. The switch marked Table controls the output on J30 pins #26 & #27. Connect
your fume extraction motor ON/OFF relay to these pins, max contact current is 1A.
Connect your laser pointer +voltage to J30 pin #36. From an external power source connect the ground straight to the pointer and the +volt-
age to J30 pin #37. The laser pointer output is activated by the switch marked Pointer.
To Next Page
Loading...