iCNC XT
5-24 OPERATION Manual 0-5299
5.7.10 Marker On/Off/Auto Switch
• ON position will activate the marker. This is used for testing.
• AUTO position will be used when a cutting program includes marking.
• OFF position will prevent activating the marker from a cutting program.
NOTE
Note the marker down switch usage.
5.7.11 Marker Down On/Off/Auto Switch
• ON position will activate the marker down signal.
• AUTO position is where you normally keep this switch.
• OFF position will prevent activating the marker down from a cutting program.
To Next Page
Loading...
