FRONT SUSPENSION / CONTROLS
12.25
12
© Copyright 2012 Polaris Sales Inc.
9924047 - 2012-2013
VICTORY Cross Roads / Cross Country Service Manual
8. Remove cables from throttle grip. Do not kink or bend
the cables.
9. Remove cables from lower switch.
10. Take note of the cable routing before removing
cables.
• Through opening in right side of upper triple
clamp.
• Through tie strap on right side of steering head
with clutch cable. This tie strap must not be pulled
tight upon installation. Cables must be able to
move freely in strap.
11. Remove cables.
Throttle Cable Installation
1. CABLE IDENTIFICATION: The throttle opening
(pull) cable is darker in color at the throttle body end.
It is the front-most cable in the switch cube and the
lower-most cable in the throttle body bracket.
On vehicles equipped with cruise control, the throttle
“push” cable can be identified by the cruise-cancel
switch near the throttle body end.
2. Route the cables as noted in Step 10 of Removal
procedure.
3. Arrange throttle opening (pull) cable toward the front
of the right hand switch cube. Arrange the cables to
route smoothly toward the throttle body without
twisting around each other.
4. Feed the inner cables up through the switch cube.
Cables should lie flat against the switch (switch shown
removed for clarity).
To Next Page
Loading...
