Victron energy MultiPlus Series User Manual

5
EN ES Appendix
2.4.9 Three-phase operation
The MultiPlus can also be used in 3-phase wye (Y) configuration. To this end, a connection between the devices is made by means of
standard RJ45 UTP cables (the same as for parallel operation). The system (Multis plus an optional control panel) will require
subsequently configuration (see Section 3).
Pre-requisites: see Section 4.4.8.
Note: the MultiPlus is not suitable for 3-phase delta (Δ) configuration.

Victron energy MultiPlus Series Specifications

General

Input voltage range	187-265VAC (230VAC models) 93-130VAC (120VAC models)
Output voltage	230VAC or 120VAC
Frequency	50Hz or 60Hz
Efficiency	Up to 96%
Operating temperature range	-40°C to +65°C
Protection Category	IP21 or IP22
Standards	EN/IEC 62109-1, EN 55014-1
Battery voltage	12V, 24V, 48V
Protection	Overload, short circuit, over temperature, battery over voltage, battery under voltage
Communication	VE.Bus
Power output	800VA to 15kVA
AC Connection	Screw terminals