PAGE 20 VIDEONICS TITLEMAKER 2000
VIDEONICS
VIDEO TIT LEMAKER 2000
A
E
C
IN INOUT OUT
D
T
VIDEONICS
THUMBS UP
™
Video Editor
DIGITAL VIDEO MIXER
VIDEONICS
VIDEONICS
VIDEO TIT LEMAKER 2000
A
BC
INOUT OUT
D
IN
In the first setup, the camcorder (A) is connected through Thumbs Up (E)
and the TitleMaker 2000 (C) to the recorder (D). In the second setup, the
camcorder (A) is connected through a Digital Video Mixer (B) to
the TitleMaker 2000 (C) and it is connected to the recorder (D).
Note that other hookups may be more suitable for your setup, as ex-
plained in the rest of this chapter.
Single-Source Editing Setup
A single-source editing setup uses a camcorder or VCR (player) to play
scenes from an original tape. The desired scenes are recorded on a blank tape,
leaving the unwanted scenes behind. An edit controller may be used to control
the player and trigger the recorder for accurate edits.
The TitleMaker 2000 can add titles as the scenes are recorded on the new
tape. To do this, the titler is connected between the player and the recorder:
VIDEONICS
VIDEO TITLEMAKER 2000
When an edit controller is used, the titler may be used between the edit
controller and the player, or between the edit controller and the recorder.
Either arrangement is likely to work unless the edit controller relies on
information that is coded in the invisible portions of the video signal (vertical
interval time code, or VITC). If that is the case, the titler may interfere with
the time code when titles replace the incoming video. Follow the instructions
in the edit controller’s manual. If there are no instructions, connect the
TitleMaker 2000 between the edit controller and the recorder:
VIDEONICS
VIDEO TITLEMAKER 2000
T
VIDEONICS
THUMBS UP
™
Video Editor
If you experience problems with this setup, connect the TitleMaker 2000
between the player and the edit controller instead.
To Next Page
Loading...
