Videonics TM-2000 - Erasing Memory and Resetting Unit; Moving the Cursor; Projects

PAGE 80 VIDEONICS TITLEMAKER 2000
Erasing Memory and Resetting Unit
• You can erase everything in a project by pressing COMMAND + SHIFT +
DELETE. The trashcan symbol appears to warn you everything is about to
be erased. Press NEW LINE/OK to confirm you really want to erase
everything. Press UNDO immediately if you do not want to erase the
project.
• To completely reset the unit, erasing everything and returning the unit to
factory condition, remove the power cord and hold COMMAND + SHIFT
while you plug the unit back in. Hold the keys until the power light goes
out. Warning: This will erase all projects, all colors, etc. You cannot undo
this operation.
Moving the Cursor
• In the Editing Screen, the COMMAND and SHIFT keys modify the arrow
keys:
Modifier key LEFT or RIGHT arrow UP or DOWN arrow
SHIFT Next start or end of line Start or end of next page
COMMAND Next start or end of line Start or end of current project
COMMAND + SHIFT Next start or end of line Start of next project
• In the Page Index screen, SHIFT causes the arrow keys to move a screenful
at a time. COMMAND causes the arrow keys to move a project at a time.
COMMAND + SHIFT also moves a project at a time.
• SHIFT and COMMAND also modify the meanings of the MARK START
and MARK END keys, in both the Editing Screen and the Page Index
screens:
• SHIFT + MARK START places a mark at the start of the current page
and SHIFT + MARK END places a mark at the end of the page.
• COMMAND + MARK START places a mark at the start of the current
project and COMMAND + MARK END places a mark at the end of the
project.
Projects
• Use COMMAND + SHIFT + UP/DOWN to move to the next or previous
project.
• COMMAND + NEW PAGE, while the Page Index is on the screen, creates
a new project.
• COMMAND + SHIFT + DELETE while in the Editing Screen erases the
contents of a project.