Videx GSM Lite 4000 Series - Art. 4811 Technical Information; Art. 4811 GSM (Lite) Module; Speaker Volume Adjustment (Dip-Switch Settings); Nameplate Illumination Jumper JP2

66250756-EN - V2.1 - 05/11/19
- 10 -
4000 Series GSM Lite Audio Intercom - Technical Manual
4000 Series GSM Lite Audio Intercom
Art. 4811 Technical Information
ART. 4811 GSM LITE MODULE
Internal jumper JP2
Nameplate LED illumination adjustment
103mm
120mm
Fig. 7
SPEAKER VOLUME ADJUSTMENT DIPSWITCH SETTINGS LEGEND
There are 2 dip-switches located on the back of the GSM module next to the
antenna connection, see Fig.7,
. They can be used to adjust the volume from
the door intercom speaker (see table below). Additionally, the volume can also
be adjusted during a call electronically via the telephone keypad (refer to user
command table on page 43).
Internal nameplate LED jumper (JP2)
Nameplate window
Call button
Intercom speaker
Current rmware version (GSMLT X.X.X)
Dip-Switch
Dip-Switch Status
Gain (dB)
Power input and auxiliary terminal AO1
Dip No.1 Dip No.2
GSM function terminals (g, 1 - 8)
12
ON
ON ON 6
Relay output (C, NC and NO)
Antenna connection
12
ON
ON OFF 12
SIM card holder
12
ON
OFF ON 18
Speaker volume dip-switches
12
ON
OFF OFF 23.5
NAMEPLATE ILLUMINATION JUMPER JP2
The nameplate LED illumination jumper JP2 is located behind the GSM module’s
front facia, shown in Fig.7,
. To access the jumper the facia must be removed
and the jumper can be adjusted as required. When JP2 is set in position A (upper
2 pins) the LED is set for bright illumination, when JP2 is set in position B (lower
2 pins) the LED is set for low illumination and if JP2 is completely removed this
will disable the nameplate LED’s, see Fig.8.
JP2 JP2 JP2
Fig. 8