Videx GSM Lite 4000 Series - Reset Procedure; Resetting the GSM Module to Factory Defaults; Full System Reset

66250756-EN - V2.1 - 05/11/19
- 26 -
4000 Series GSM Lite Audio Intercom - Technical Manual
4000 Series GSM Lite Audio Intercom
Reset Procedure
RESETTING THE GSM MODULE TO FACTORY DEFAULTS
There are two ‘hard-wired’ reset options available. The rst will reset the master code (1111) only and the second will reset everything
and clear all the stored telephone numbers (primary, divert and dial to open) and all settings.
RESETTING THE MASTER CODE TO 1111 4x1
1. Power down the GSM LITE intercom module.
2. Put a short across terminals g & 7 on the back of the GSM
LITE module, as shown in Fig.37.
3. Power up the GSM LITE module, 2 beeps will be heard
followed by a brief delay and then a 3rd beep, as shown in
Fig.38.
4. After the 3rd beep remove the short, as shown in Fig.39.
5. The master code is now reset back to 1111 (4x1).
Fig. 37
...delay...
Fig. 38
Fig. 39
FULL SYSTEM RESET
1. Power down the GSM LITE intercom module.
2. Put a short across terminals g & 8 on the back of the GSM
LITE module, as shown in Fig.40.
3. Power up the GSM LITE module, 2 beeps will be heard
followed by a brief delay and then a further 2 beeps, as
shown in Fig.41.
4. After the 4th beep remove the short, as shown in Fig.42.
5. All settings on the GSM LITE module are returned to
factory defaults.
Fig. 40
...delay...
Fig. 41
Fig. 42