Videx GSM Lite 4000 Series - Fitting the SIM & Connecting Power; Fitting the SIM Card and Connecting the Power to the GSM Intercom; Power Up Initialisation Sequence

66250756-EN - V2.1 - 05/11/19
- 25 -
4000 Series GSM Lite Audio Intercom - Technical Manual
4000 Series GSM Lite Audio Intercom
Fitting the SIM & Connecting Power
FITTING THE SIM CARD AND CONNECTING THE POWER TO THE GSM INTERCOM
After connecting the power supply, antenna, lock output and any auxiliary devices as shown in this manual and before powering up,
a SIM card must be installed (the SIM must already be registered with the network provider). The SIM holder can be found on the back
of the module under the SMA antenna connection. A SIM card from most network providers can be used (remember a network 3 SIM
will only work with the 3G version of the GSM LITE intercom). Follow the steps below to insert the SIM card.
FITTING THE SIM
1. On the back of the Art.4811 GSM LITE module slide the
SIM holder to the left until it ‘clicks’, as shown in Fig.30.
2. The SIM holder is hinged and will open out to the left,
see Fig.31.
3. Place the SIM card into the holder (it will only t one way,
see Fig.32) and fold the holder back down, see Fig.33.
4. Slide the SIM holder back to the right until it ‘clicks’, see
Fig.34.
5. Once the SIM is in place connect the Art.432 GSM antenna
and then connect the 12Vdc power supply but DO NOT
power up the system yet.
6. Follow the initialisation process described below.
Fig. 30 Fig. 31
Fig. 32 Fig. 33
Fig. 34
POWER UP INITIALISATION SEQUENCE
The Art.4811 GSM LITE module requires approximately 30 seconds to initialise properly. We
recommend NOT sending any SMS messages or pressing buttons during this time.
1. First check all the necessary connections have been made correctly, following the wiring
diagrams shown in this manual, and when ready power up the system.
2. Two short beeps will be heard from the GSM LITE module followed by a 15 second delay,
as shown Fig.35.
3. Next a single short beep will be heard every second while the GSM module attempts to
register with the chosen network, as shown in Fig.36, this will continue until the GSM LITE
module has made a connection to the network.
4. Wait for the beeping to stop to indicate that the GSM LITE module has registered with the
network.
5. The GSM LITE intercom is ready to be programmed.
...delay 15 secs...
Fig. 35
...registering...
...1 sec...
...1 sec...
Fig. 36