66250675-EN - V1.0 - 05/09/17
35
4000 Series Vandal Resistant GSM - Technical Manual
4000 Series Vandal Resistant GSM Audio Intercom with Proximity Facility
4000 Series Back Box Installation
INSTALLING A SURFACE MOUNT DOOR STATION
1. Place the surface box against the wall (165-170cm between the top of the box and the oor level as shown in Fig.47) and mark
the xing holes
for the wall plugs and the hole for the cables (Fig.48). Observe the orientation of the surface box with
the hinge mount
on the left;
In order to prevent water ingress we highly recommend using a silicon sealant between the wall and the back box ,
ON THE LEFT, TOP AND RIGHT SIDES ONLY AND AROUND ALL THE HOLES
. DON'T USE SILICON SEALANT ON THE
BOTTOM SIDE OF THE BACK BOX Fig.49;
2. As shown in Fig.48, drill the xing holes , insert the wall plugs and feed the cables through the surface box opening
, x the surface box to the wall using the screws ;
3. Next t the neoprene seal
(removing the thin lm rst) along the top side of the module , as shown in Fig.50;
4. Before installation of the module support frame
to the surface box , t the module to the support frame as shown
in Fig.51 then, as shown in Fig.52, t the module xing brackets
using the xing screws ;
5. Next take the frame’s hinges
and hook the module support frame to the surface box , starting from the left following
the guide arrows, as shown in Fig.53. Ensure that the frame’s hinges
(Fig.53) t inside the relevant hinge mounts inside the
surface box
, following the guide arrows, as shown in Fig.54;
6. Pull back the module support frame
from the surface box while moving it slightly to the left, following the guide arrows,
as shown in Fig.55;
7. Next open the module support frame
and clip the hinge locks to the hinge mounts , following the guide arrows, as
shown in Fig.56;
8. Take the cable wires
and make the required wiring connections into the terminals on the back of the module , as
shown in Fig.57, using the screwdriver provided
(from Fig.58 and using the at blade end);
9. Make any other necessary panel adjustments required, tting the SIM card and setting the dip-switches etc. For the button
module conguration refer to Fig.3 and the button harness table on page 7 and for connecting the antenna refer to Fig.7 on
page 9;
10. After the system has been tested and is working correctly, move back the module support frame
carefully and then x it to the
surface box
using the screwdriver provided (using the torx end) and the torx pin security screws provided , as shown in
Fig.45. Note: do not over tighten the screws more than is necessary.
Note: if additional holes are made in the surface box, oxidation problems may appear unless the unprotected metal is
coated with a protective paint.
NOTES
• The screwdriver's blade has two sides, one at and one torx, to select one of them unplug the blade from the screwdriver body
and plug it into the required side;
• The example shows the use of only one back box hole
for the wires, this is done to keep the le drawings clear. Naturally the
installer can use more than one back box hole if required.
To Next Page
Loading...
