22
1. Hook into place two side panels.
Note
Check clearance and squareness
towards the fixing rails.
Side panels should be parallel to
each other and be flush, level and
parallel with the fixing rails at the back
and front
A
.
2. If necessary, align the rear fixing rails
and the cross braces so that the
same clearance of side panels to the
fixing rails results at the r.h. and l.h.
side.
3. Then tighten all rail screws.
Note
Rear fixing rails may be secured
below on the base support using
M 6x10 screws.
4. Unhook the two side panels again.
Fitting the thermal insulation
(cont.)
5614 451 GB
To Next Page
Loading...
