12
Getting Started
Carefully remove your Bardot from its box. You may wish to store the packaging for future use.
Inside the box you will nd:
- Your Bardot
- Power Adapter with plugs for UK and mainland Europe
- User Manual
Positioning your Bardot
Place your Bardot on a at / stable surface, with reference to the safety information section in this manual.
Adjusting the Aerial
The aerial should be extended to ensure you receive the best signal possible in both DAB and FM radio modes.
Later on it may be necessary to alter the position of your Bardot and its aerial to achieve the best reception.
Turning the Unit On and O
1. Connect the plug at the end of power adapter cable to the DC in jack on the back of your Bardot. Insert the
power adapter into the mains socket.
2. Turn the mains power on and then press the POWER button to turn on the unit.
Pressing the POWER button again switches your Bardot to standby mode. To switch the unit o completely,
unplug the power adapter from the mains socket.
Volume Control
Adjust the radio volume by turning the – VOLUME + knob.
Using DAB Mode
Note: When you turn on the radio it will automatically search and store all the available
stations. You should conduct an additional Full Scan to ensure all stations are picked up and
stored. It is also recommended every few months to run a new scan to pick up any new DAB/
DAB+ stations that may have begun broadcasting after purchasing your Bardot.
1. Repeatedly press the SOURCE button until DAB is shown on the display. For the rst time your Bardot will
carry out a full scan and store a list of stations in memory.
To Next Page
Loading...
Need help?
General
