View Quest Bardot - Backlight, Language, and Reset

GB
27
Bardot Operation Guide
6. To cancel Alarm, refer to steps1-3 to set Alarm states to ‘O’.
Backlight Level
To change the backlight level of standby mode and power on mode, press SNOOZE repeatedly while alarm is
not sounding. Or using the menu:
1. Press the MENU button and then turn the - TUNING + knob to select System menu. Press the - TUNING +
knob to conrm.
2. Turn the - TUNING + knob to select Backlight menu and press the - TUNING + knob to conrm.
3. Turn the - TUNING + knob to select backlight level, and press the - TUNING + knob to conrm the setting.
Power On - High
Medium
Low
Standby - High
Medium
Low
Language
1. Press the MENU button, and then turn the - TUNING + knob to select System menu. Press the - TUNING +
knob to conrm.
2. Turn the - TUNING + knob to select Language menu and press the - TUNING + knob to conrm.
3. Turn the - TUNING + knob to select language and press the - TUNING + knob to conrm.
Factory Reset
Factory reset resets all user settings to default values, so time/date, alarm settings, presets and Bluetooth
settings are lost.
1. Press the MENU button, turn the - TUNING + knob if necessary to select System menu and press the - TUNING
+ knob to conrm. Then turn the - TUNING + knob to select Factory Reset. Press the - TUNING + knob to
conrm.
2. Turn the - TUNING + knob to ‘Yes’, and then press the - TUNING + knob to conrm. Display will show
“Restarting” and your Bardot will reset to Factory settings.
Software Version
Note: The helpdesk may ask you for the software version of your product.
1. Press the MENU button, and then turn the - TUNING + knob to select SW Version. Press the - TUNING + knob
to conrm. Display will show “SW Version” and below it your Bardot’s software version, scrolling as necessary.