3
Safety Precautions
Please read the following Safety Precauons before you start using the projector.
• Keep this user guide in a safe place for later reference.
•
• Allow at least 20“ (50 cm) clearance around the projector to ensure proper
•
•
•
•
beam may damage your eyes.
•
on.
•
•
cool for approximately 45 minutes prior to removing the lamp assembly for
replacement.
•
rated life could cause them to break on rare occasions.
• Never replace the lamp assembly or any electronic component unless the
projector is unplugged.
•
inside which may cause death if you should come into contact with live parts.
• When moving the projector, be careful not to drop or bump the projector on
anything.
•
•
• Avoid exposing the projector to direct sunlight or other sources of sustained
of the projector to dangerous levels.
To Next Page
Loading...
Need help?
General
