Fig.7-2
7.4 Assemble Thermal Pad & Gasket Hest-sink then place contact DMD (Fig. 7-3,7-3-1).
1.>Press center of Heatsink before assemble spring screws, then keeps press until
spring screw assembly finish.
2.>Pre-fastening Sequence: [ 1 ] - [ 2 ] - [ 3 ] - [ 4 ].
3.>Fastening Sequence: [ 2 ] - [ 1 ] - [ 4 ] - [ 3 ].
4.>Screw Torque must be confirmed to be 6 kg-cm.
Fig. 7-3
Fixed holes of DMD
Press Heatsink when
assemble spring screw
Confidential - Do Not Copy
PJD5122
ViewSonic Corporation
To Next Page
Loading...
