ViewSonic PJL7201 - Powering the Projector On and Off; Power On Procedure; Power Off Procedure

ViewSonic 10
PJL7200/PJL7201/PJL7202
Setting Up
Power ON / OFF
AC IN
Turning on the power
1. Make sure that power cord is firmly and
correctly connected to the projector.
2. Remove the lens cover, and the POWER
indicator will light up in green.
3. Press POWER button on the control panel or
the remote control to turn on the projector.
4. Rotate the zoom ring to adjust the screen size.
5. Rotate the focus ring to adjust the focus.
Turning off the power
1. Press the POWER button on the control
panel or the remote control. The “power off”
conrmationmessageappears.
2. Press the POWER button again while the
message appears.
3. When the projector enters “Standby” mode,
the POWER indicator will light up in green.
4. If you don’t use the projector, remove power
cord.
WARNING

Do not touch around the lamp cover and the
exhaust vents during use or just after use, since it
is too hot.
POWER indicator
AC inlet
Outlet
Focus ring
Zoom ring
Power off?
Please press
key again to power off.
WARNING

A strong light is emitted when the projector’
s power is on. Do not look into the lens of the
projector or look inside of the projector through
any of the projector’s openings.