Network Control Software Application
Register the projector(s) which needs to be controlled.
“ Auto search ” can help you to seek the projector(s) source easily.
After registering in the work group, you can start to control the projector.
Group the projector(s) into different sections.
You can monitor the status easily by the sort of group name function in the network.
Monitor the status for each projector.
a.You can manage and change the monitoring content by System Parameter Setting.
b.TheLamptimer,lterworkingtimeorsystemwarningfeedbacketc.canbeknown
by checking the status for projector(s).
Control the booked projector(s).
The status can be refreshed and acquired by monitoring functions; you can also
operate the function easily by Network Control.
NOTE
To monitor and control the projector(including stand-by mode), the following
conditions need to be ready:
(1) Projector should already be powered on.
(2) Projector is connected to network.
(3) LED light of the projector network port shows normal. (Green light on, Orange
twinkle)
*
Stand-bymodeindictor:GreenLED(Power)ontheprojector’scontrolpanelashes.
NOTE: This Network Control Software Application is an optional function and support
model with RJ45 LAN port only.
Lan
To Next Page
Loading...
