Lamp
1. If you want to replace new lamp, but the projector was just turned off,
please let the projector cool down and unplug power cord at least 60
minutes.
2. If the projector is mounted in the ceiling, contact your dealer to replace
the lamp.
Replacing New Lamp
1. Remove the lamp door.
2. Loosen 2 screws of the lamp holder. Take the handle on the top of the
lamp, pull out the lamp straight off the projector.
3.Insertnewlamp,lockthelampdoorrmlywith2screws.
4. Put the lamp door on.
5. Please reset the lamp timer after replacing lamp. (P.26)
To Next Page
Loading...
