Modify The Projector Setting
If modifying the registered projector setting is needed, please move your cursor to
the data table and click the item that you would like to modify, the detail will be
shown on the right side table.
< Graph 5 > : Register Table.
After setting, you can save the data by clicking button or cancel by clicking
button.
Item Description
Display name
Show the Host name
(16 characters at most in ASCII)
IP Address Show the IP Address
Mask Show the Mask
Gateway Show the Gateway
MAC
Show up the MAC code
(Thedefaultvaluecannotbemodied)
Monitor
Show up the projector monitor status
(The default set in power on status)
DHCP
Capture IP address from network sensor
automatically.
< Table 3 > : Setting Windows
To Next Page
Loading...
