ViewSonic PJL7201 - Adjusting Projector Elevation

ViewSonic 13
PJL7200/PJL7201/PJL7202
Setting Up
Adjusting The Projector’s Elevation
Use the adjustable foot at the front of the projector to set the image height.
1
Holding the projector, push the foot adjust
buttons to loosen the front adjustable foot.
12
Position the front side of the projector to the
desired height.
3
Release the foot adjust buttons in order to
lock the front adjustable feet.
14
After making sure that the front adjustable
feet are locked, put the projector gently
atop.
CAUTION
* The adjustment range of front adjustable
foot is 0 to 8.5 degrees.
* When the foot is adjusted, it may cause the
shape of the projected image to become
distorted. Use the keystone correction
function to correct this distortion.