ViewSonic PJL7201 - Security Settings Management; PIN Lock Protection Configuration; Modifying the PIN Code

ViewSonic 31 PJL7200/PJL7201/PJL7202
MENU
Advanced Menu
Step:
1.Usethe▲/▼buttons
to select an item.
2.Usethe◄/►buttons
to select an item or
adjust the value.
Item Selection Description
PIN LOCK
PROTECTION
OFF
ON 1
ON 2
OFF: Turn off PIN lock protection.
ON1:PINcodeisneededonlyinthersttimeafterAC
power has been switched off.
ON 2: PIN code is needed every time while the projector
is turned on.
CAUTION:
Once the PIN code had been set, the projector cannot
be used unless you enter the correct PIN code.
MODIFY PIN EXECUTE
1. Press “ MENU ” on the projector or remote control.
2.Usethe►buttontoselecttheMODIFYPINitemofthe
SECURITY category.
3.Pressthe►buttontochangePINLOCKPROTECTION
mode.
4. Please enter the original PIN code.
(a) If the PIN is correct, system will allow you to change
a new PIN code.
(b) If the PIN is incorrect, a “ Code Error ” message will appear.
5.PleaseenteranewPINcode.Andthenenteragaintoconrm.
NOTE:
(1) To change the PIN lock protection state, you must
enterthePINcoderst.
(2)Pleaseenter:0000forrst-timeuse.
(3) Write your selected password down here in this
manual to help you remember it; see the selection
“Appendix”.
(4) To avoid unnecessary trouble, if you activate the [PIN
Lock Protection], it is highly recommended that you
write down the PIN code and store it in a safe place.