ViewSonic VPC100 - Page 34

ViewSonic VPC100
23
BIOSSetupUtility
BootSettingsConguration
With this sub-menu, you can congure the type of system boot to execute.
• QuickBoot: Enable Quick Boot to allow BIOS to skip certain tests while
booting. This will decrease the ti me needed to boot the system.
• Fulllogodisplay: When disabled, the normal POST (Power On Self
Test) messages are displayed when the system boots up. When enabled,
ViewSonic
®
logo is displayed instead.
• BootupNum-Lock: Turn the “Power-on state for Numlock” on or off.
BootDevicePriority
This sub-menu lets you specify the boot priority sequence from the available
devices.
To change the specied device, press [Enter] to select an available device from
the list.