EasyManuals Logo

ViewSonic VT2430 User Manual

ViewSonic VT2430
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
4ViewSonic VT2430
ENGLISH
Antenna Installation Instructions
1. Outdoor Antenna Grounding
If an outside antenna or cable system is connected to the product be sure the antenna or cable system is
grounded so as to provide some protection against voltage surges and built-up static charges, Article 810
of the National Electrical Code, ANSI/NFPA 70, provides information with regard to proper grounding of
the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, connection to
grounding electrodes, and requirements for the grounding electrode.
2. Lightning
For added protection for this product during a lightning storm, or when it is left unattended and unused for
long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will
prevent damage to the product due to lightning and power-line surges. Do not disconnect the antenna or the
power cord during a heavy storm lighting may strike while you are holding the cable cord, causing serious
injury; turn off your LCD Display and wait for the weather to improve.
3. Power Lines
An outside antenna system should not be located in the vicinity of overhead power lines or other electric light
or power circuits, or where it can fall into such power lines or circuits, When installing an outside antenna
system, extreme care should be taken to keep from touching such power lines or circuits as contact with them
might be fatal.
Cleaning the LCD Display
Make sure the LCD Display is turned off.
Never spray or pour any liquid directly onto the screen or case.
To clean the screen:
1. Wipe the screen with a clean, soft, lint-free cloth. This removes dust and other particles.
2. If still not clean, apply a small amount of non-ammonia, non-alcohol based glass cleaner onto a clean, soft,
lint-free cloth, and wipe the screen.
To clean the case:
1. Use a soft, dry cloth.
2. If still not clean, apply a small amount of a non-ammonia, non-alcohol based, mild non-abrasive detergent
onto a clean, soft, lint-free cloth, then wipe the surface.
Disclaimer
ViewSonic
TM
does not recommend the use of any ammonia or alcohol-based cleaners on the LCD Display screen
or case. Some chemical cleaners have been reported to damage the screen and/or case of the LCD Display.
ViewSonic will not be liable for damage resulting from use of any ammonia or alcohol-based cleaners.
Antenna
Antenna discharge unit
Grounding conductors
Power service grounding electrode system
Ground clamps
Electric service equipment
Ground clamp

Other manuals for ViewSonic VT2430

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ViewSonic VT2430 and is the answer not in the manual?

ViewSonic VT2430 Specifications

General IconGeneral
Power LEDYes
Headphone connectivity3.5 mm
Digital vertical frequency60 - 75 Hz
Digital horizontal frequency30 - 64 kHz
Operating relative humidity (H-H)10 - 65 %
Operating temperature (T-T)0 - 40 °C
Package weight9000 g
CertificationFCC, cUL (UL), RoHS, NOM, BETS-7, CB
Audio (L/R) in1
Card reader integratedNo
Product colorBlack
LED indicatorsStand-by
Panel mounting interface100 x 100 mm
AC input voltage100 - 240 V
Power consumption (typical)60 W
Display diagonal24 \
Display brightness300 cd/m²
Display technologyLCD
Native aspect ratio16:9
Viewing angle, vertical170 °
Contrast ratio (dynamic)10000:1
Display number of colors16.78 million colors
Viewing angle, horizontal160 °
RMS rated power10 W
Number of speakers2
Tuner typeAnalog & digital
Weight and Dimensions IconWeight and Dimensions
Depth (with stand)211 mm
Width (with stand)567 mm
Height (with stand)442 mm
Weight (with stand)7000 g
Depth (without stand)85 mm
Height (without stand)387 mm
Weight (without stand)6500 g

Related product manuals