10
www.vigocool.eu
by the user. After selecting a new temperature, the refrigerator will begin to cool down and
the value on the display will begin to change.
In order to change the temperature unit, turn off the refrigerator and then hold down the
"SET" button. E1 will appear on the display. Press the "SET" button to change the symbol to
E5. There you can use ˄ (+) or ˅ (–) to change the units between Celsius (°C) and Farenheit
(°F). Celsius is set by default.
Refrigerators have the option of choosing a cooling mode. The two modes are MAX (fast
cooling, more energy consumption) and ECO (slower cooling, less energy consumption). The
default is MAX mode. To change the mode, press the "SET" button when the refrigerator is
turned on.
The V35 refrigerator has temperature control only in the larger compartment (freezing and
cooling from +10C to -20C). The smaller chamber is a refrigerator and its temperature
depends on the temperature in the freezer (when freezing -20C, the refrigerator is about
+1C). The smaller chamber has no freezing option (the temperature range of the smaller
chamber is from +1C to +20C). Example values of the temperature dependence between the
set temperature in the freezing section (upper row) and the temperature obtained in the
cooling section (lower row) are presented in the table below:
3.5. Battery protection mode
Refrigerators have three battery protection modes. They are shown as letters on the display:
L (low), M (medium) and H (high).
To Next Page
Loading...
