VIGO COOL V30D - Temperature Settings, Change of Operating Mode; Battery Protection Mode

15
www.vigocool.eu
3.4. Temperature settings, change of operating mode
The temperature of the refrigerator can be changed using the + (temperature increase)
and – (temperature decrease) buttons. After selecting the correct temperature, wait 4
seconds to save the current settings. The refrigerator will begin to cool down to the
selected value. The display shows the CURRENT temperature, not the temperature
selected by the user. After selecting a new temperature, the refrigerator will begin to cool
down and the value on the display will begin to change.
The refrigerator has temperature control only in the larger compartment (freezing and
cooling from +10C to -20C). The smaller chamber is a refrigerator and its temperature
depends on the temperature in the freezer (when freezing -20C, the refrigerator is about
+1C). The smaller chamber has no freezing option (the temperature range of the smaller
chamber is from +1C to +20C). Example values of the temperature dependence between
the set temperature in the freezing section (upper row) and the temperature obtained in
the cooling section (lower row) are presented in the table below:
In order to change the temperature unit, turn off the refrigerator and then hold down the
"SET" button. E1 will appear on the display. Press the "SET" button to change the symbol
to E5. There you can use ˄ (+) or ˅ (–) to change the units between Celsius (°C) and
Farenheit (°F). Celsius is set by default.
Refrigerators have the option of choosing a cooling mode. The two modes are MAX (fast
cooling, more energy consumption) and ECO (slower cooling, less energy consumption).
The default is MAX mode. To change the mode, press the "SET" button when the
refrigerator is turned on.
3.5. Battery protection mode
Refrigerators have three battery protection modes. They are shown as letters on the
display: L (low), M (medium) and H (high).
The battery protection function determines the voltage at which the refrigerator will shut
down (switch-off voltage). The device will restart when the battery is charged to the