Removing Ice Bucket:
INITIAL INSTALLATION OF
WATER FILTER
1.
r on the
right hand side. (See figure 1)
• Remove ice bucket by lifting bucket
and pulling out.
• Replace ice bucket by sliding in until
bucket locks in place. Ice bucket
must be locked in place for proper
ice dispensing. If freeze door does
not close, the bucket is not in proper
location.
Dispenser Light: A light is activated
when dispensing ice or water.
• Deactivate night light by pushing
rocker switch, located underneath
dispenser and right of water
dispenser bar.
WATER FILTER INSTALLATION
NOTE: If the system will not be used
for an extended period of time, turn
water off. Removing the cartridge and
storing it in a sealed plastic bag in the
refrigerator will reduce loss of life due to
bacterial growth.
Locate water filter connection location.
The connection is located under the
Meat Savor™/ Produce drawe
2. Insert cartridge into filter head and
rotate gently clockwise until filter
stops.
3. Flush air from the system by running
water through the dispenser
continuously for 3 minutes. Continue
to run water if water spurts occur until
water runs steady. Additional flushing
may be required in areas with poor
quality water.
NOTE: Allow 1-2 minutes delay in water
dispersal to allow internal water tank to
fill.
42
To Next Page
Loading...
