Viking G-5 - Motor Cable - Secondary (Dual)

VIKING TECHNICAL SUPPORT 1.800.908.0884
21
Motor Cable - Secondary (Dual)
NOTE: The Primary/Secondary, or Dual, Electronic Control Unit is equipped with both
the VFlex Control Board (Primary) and a Secondary Module, both are required to
operate two gate motors in tandem.
ELECTRICAL INSTALLATION - STANDARD ECU
STEP 6
Secondary Motor:
a. Connect motor cable to the
terminal block at the Secondary
Module as illustrated, according
to the color code provided.
b. Attach the grounding wire (non
insulated) to the Board Mounting
Plate using the screw provided.
STEP 5
Secondary to Primary Connections:
a. Ensure that the Secondary Power
Harness is connected as illustrated.
Polarity is important! Red to “+”
Black to “–”
b. Ensure that the Primary/Secondary
Communication Cable is connected
as illustrated.
5a
5b
6b
6a
Secondary Motor
BLUE
BLACK
NOT CONNECTED
YELLOW
BROWN
RED
ORANGE
Primary Motor
BLUE
BLACK
NOT CONNECTED
YELLOW
BROWN
RED
ORANGE
7
STEP 7
Secondary Open Left or Open Right: Refer to the illustration on page 20.
Place the terminal block in the proper location for the gate opening direction.
• “OPEN RIGHT” Connector if the gate opens to the INSIDE (pull to open).
• “OPEN LEFT” Connector if the gate opens to the OUTSIDE (push to open).
COM
N.O.
N.C.
Yellow
Orange
COM
N.O.
N.C.
Brown
Red
Limit Switch
Limit Switch
O
r
a
n
g
e
Y
e
l
l
o
w
B
l
u
e
B
l
a
c
k
B
r
o
w
n
R
e
d
To Limit
Switches
To Motor
Wire Lead
From Control Box
Reference Wiring Diagram