Viking G-5 - Control Board Setup; Initial Settings; Speed; Overlap Delay

VIKING TECHNICAL SUPPORT 1.800.908.0884
24
CONTROL BOARD SETUP
Initial Settings
“Timer”
Hold Open Timer
Automatically closes the gate after
the selected amount of time from 1-60
seconds.
Turning the dial between “0” and “OFF”
will disable this feature, requiring a close
command to close the gate.
“Speed”
Motor Speed
Increases or decreases the speed of gate
travel.
“Overlap”
Overlap Delay
Delays the gate from opening for the
selected amount of time from 1-6 seconds.
! For Primary/Secondary or dual
applications, the Primary will delay to
open and the Secondary will delay to
close.
“ODS”
Obstruction Detection Sensor
Sets the amount of force required to trip
the inherent obstruction sensor.
See page 26 for more details about this
feature.