1. Remove the hex head screw securing the temperature sensor assembly to the back wall of the
cabinet liner.
2. Lift the right side of the assembly slightly and unhook the tab on the left end from the slot in the
cabinet liner.
3. Unhook the locking arm on the temperature sensor connector from the tab on the wiring harness
connector and unplug the connectors.
Servicing the Meat Savor Control
The control for the meat savor air baffle is located on the left side of the rear wall of the refrigerator
section and will require that the meat savor shelf and drawer be removed for access.
1. Remove the four hex head screws securing the meat savor control to the cabinet liner.
2. Remove the control knob, control cover, styrofoam cavity and baffle.
16
To Next Page
Loading...
