INSTALLING CUSTOM SIDE PANELS
If built-in area depth is 25" (63.5 cm) or more, custom side panels can be installed inside the side trim or attached to
the outside of the side trim. If the side panels will be installed inside the side trim and the panels are more then 1/8"
(3.2 mm) thick, route front edge of panel to fit side trim piece. If panels are less than 1/8" (3.2 mm) thick, install a
filler panel between sides and custom side panels. Follow specific installation instructions provided with custom
INSTALLING TOP GRILL
To remo
3. s to remove grill assembly
INS EIGHT TOP GRILL
3. s to remove grill assembly
4.
in place with screws, repeat
5.
6. ones that correspond
8. . Pull down
slightly to lock into place.
ve:
1. Grasp louver area.
2. Push straight up, then pull straight out.
Loosen (4) screw
from unit.
TALL DIFFERENT H
1. Grasp louver area.
2. Push straight up, then pull straight out.
Loosen (4) screw
from unit.
Remove louvers from mounting brackets.
Align new brackets with holes on one end of
louvers. Fasten
at opposite end.
Remove screws attaching top trim to guard.
Readjust trim according to new grill height.
Replace end caps with
with new grill height.
7. Reattach grill assembly.
Replace louver assembly
63
To Previous Page
Loading...
