© 2010 Viking Preferred Service
23
Diagnostics
Door Disassembly (cont.)
Detergent Dispenser
The image below shows a close-up of the detergent
dispenser. In order to remove the dispenser, first
remove the six T15 TORX® 1/2” screws and the
two brackets, which hold the dispenser in place
(brackets indicated by the red dotted line below).
The image below shows the solenoid unplugged
to remove the dispenser assembly. Unplug the
two-wire connector plug in order to remove the
dispenser.
Door Latch Interlock
The door latch mechanism is secured to the inner
door panel by two T15 TORX® 3/4” screws. With
the control panel removed, remove the two screws.
Remove the latch mechanism and unplug the 2-wire
connector plug from the micro switch shown below.
If replacing the switch, remove the bracket from the
old switch and reinstall on the replacement latch
assembly. Remove the TORX® screw shown below.
12 VDC
Screw
Screw
DANGER
Failure to observe caution could result in electric
shock, resulting in permanent injury or DEATH.
To Next Page
Loading...
